This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
solvers:forcetostress [2012/11/20 23:05] gag [SIF contents] |
solvers:forcetostress [2019/01/16 10:00] (current) mondher [Examples] |
||
---|---|---|---|
Line 13: | Line 13: | ||
==== General Description ==== | ==== General Description ==== | ||
+ | For a given boundary, this solver computes the nodal stress equivalent to a given nodal force. Force here means the result of a variable, named stress, which is of the same units than the force but per unit-area in 3D or unit-length in 2D. This can be used also to infer the flux from the value of a debit or to infer a tangential stress from the value of a tangential force. | ||
==== SIF contents ==== | ==== SIF contents ==== | ||
- | For a given boundary, this solver computes | + | In the SIF example below, the normal |
< | < | ||
Solver 1 | Solver 1 | ||
Line 24: | Line 23: | ||
Stabilization Method = String Stabilized | Stabilization Method = String Stabilized | ||
Flow Model = Stokes | Flow Model = Stokes | ||
- | |||
... | ... | ||
- | Exported Variable 1 = Flow Solution Loads[Fx:1 Fy:1 Force:1 CEQ Residual:1 ] | + | Exported Variable 1 = Flow Solution Loads[Fx:1 Fy:1 Fz:1 CEQ Residual:1 ] |
Calculate Loads = Logical True | Calculate Loads = Logical True | ||
End | End | ||
Line 33: | Line 31: | ||
Solver 2 | Solver 2 | ||
Equation = " | Equation = " | ||
- | Procedure = File "./ | + | Procedure = File "ElmerIceSolvers" " |
Variable = String " | Variable = String " | ||
Variable DOFs = 1 | Variable DOFs = 1 | ||
+ | | ||
+ | Force Variable Name = String " | ||
Linear System Solver = Direct | Linear System Solver = Direct | ||
Line 56: | Line 56: | ||
==== Examples ==== | ==== Examples ==== | ||
- | Download an example using the FlowDepth | + | |
+ | In the example | ||
+ | |||
+ | 2 more tests were added on 15-12-2018: | ||
+ | |||
+ | [ELMER_TRUNK]/ | ||
+ | |||
+ | [ELMER_TRUNK]/ |