Warning: Undefined array key -1 in /home/np29546/public_html/elmerice/wiki/inc/html.php on line 1458
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
tips:freesurface [2013/04/18 04:34] gag |
tips:freesurface [2013/11/07 17:16] mschafer |
||
|---|---|---|---|
| Line 139: | Line 139: | ||
| </ | </ | ||
| - | The material section entry for the mesh update solver then read as (have to be inserted in the glacial body's material section and values are not so important): | + | The material section entry for the mesh update solver then read as (have to be inserted in the glacial body's material section and values are not so important): |
| < | < | ||
| - | Youngs | + | Mesh Elastic |
| - | Poisson Ratio = 0.3 | + | Mesh Poisson Ratio = 0.3 |
| </ | </ | ||
| + | (Note: Youngs Modulus/ | ||
| If the model consists of a bedrock boundary, a free surface and a side boundary, the boundary condition section read as follows: | If the model consists of a bedrock boundary, a free surface and a side boundary, the boundary condition section read as follows: | ||
| Line 213: | Line 214: | ||
| End | End | ||
| </ | </ | ||
| - | Additional two instances of the [[solvers: | + | Additional two instances of the [[solvers: |
| + | //“Mass Consistent Normals = Logical True”// might be needed in the boundary conditions to ensure correct calculation of fluxes (through bedrock and lateral sides). | ||
