Problem Paraview Integration into Elmer Gui

[Brainbustling]

Hello,

i´ve got a little problem using Paraview out of Elmer Gui.
I use Elmer 8.4-7b58366a and ParaView 5.8.0-RC2-Windows-Python3.7-msvc2015-64bit.
I can start Paraview out of Elmer Gui but the output file is named "case_0001.vtu" but paraview is looking for "case0001.vtu ".
I only found in the Setup Setting of the Gui the opportunity to set the name but not the underscore.
Where can i change, that the underscore is set?

Thx for reading.

[kevinarden]

you can install paraview for windows independent of elmer and open any file you want.

Once you open paraview, even from elmer, you can do a file open and select the file you want to open.

Elmer has changed the format that it is renaming vtu files.

[kevinarden]

you can also control the file naming convention by using quotations instead of the default

Post File = "case.vtu"

in the simulation section produces


case0001.vtu

etc.

[Brainbustling]

Hi,

thx for your replay
I tried using quotations, but with no luck.
the output postfile was still named: "case_t0001.vtu".

[kevinarden]

I was in a earlier version, in the latest version the "_t" is hard coded into the code.

[Brainbustling]

ah ok well then i´ll use paraview in the standalone way.
But thx for your help