Hello fellow Users
I am new to Elmer-Gui and Forums in general. So I do appreciate the support and the patience.
I am trying to complete a modal analysis of a simple square section bar (SIF attached): 10mm x 10mm x 100mm - Generic Steel Alloy - Free-Free.
Comparing the results of this model with hand calculations (Formulas for natural frequency and mode shape - Blevins) highlights "large" discrepancies (screen shot of spreadsheet attached)!
Am I doing something wrong?
I don't believe the deviations are related to mesh refinement (exercise has been completed but results are not attached).
I don't believe the deviations are related to the specific solver (exercise has been completed but results are not attached).
Please help.
Regards
FemUser1414
PS. I am not worried about the first 6 modes as predicted by Elmer because they are rigid-body modes.
PS. Additional information:
This exercise is just to get me familiar with this package. I am planing to use Elmer-Gui for a more elaborate application: Harmonic Analysis of a pre-stressed cylindrical object. This object is pre-stressed due to shrink-fit onto a more stiff and heavier part (not sure that I want to do Contact Analysis at this stage! Maybe after investigating the initial results)
ELMER GUI - Modal Analysis
-
- Posts: 2
- Joined: 08 Nov 2017, 11:18
- Antispam: Yes
ELMER GUI - Modal Analysis
- Attachments
-
- HandCalcsVsElmer.jpg
- (191.86 KiB) Not downloaded yet
-
- case.sif
- SIF for Square bar
- (1.87 KiB) Downloaded 388 times