Dear all,
I have a problem after Run ELMERGUI.
FYI, I use GID software for structure drawing and mesh generation.
I want to get the data on the vertical boundary (as shown in the Picture : Single_NURBS-horz1.jpg ) after FEM simulation by ELMERGUI.
Therefore, I have tried to create the new NURBS (as shown in the Picture : separate_NURBS-horz1.jpg ), and used the same .sif file for ELMERGUI. (I also attached the .sif file)
The mesh was seemed to generated as I wanted. The nodes were on the vertical boundary line, however, the results were totally different.
Therefore, I want to ask you for a suggestion how can I manage with this problem?
Thank you in advance,
Kanito
Problem after adding NURBS
Problem after adding NURBS
- Attachments
-
- separate_NURBS-horz1.jpg
- (210.31 KiB) Not downloaded yet
-
- Single_NURBS-horz1.jpg
- (208.02 KiB) Not downloaded yet
-
- Add_8_L1.sif
- (3.22 KiB) Downloaded 311 times