Hi all,
I created a simple 3d model using solidworks2019, and save as .igs, but couldn't open in elmer.
I also tried to export as .step or use gmesh to get .msh file, but same results.
Does anyone know how to import 3d files from solidworks?
I really appreciate if you help me.
thanks.
import files from solidworks
-
- Posts: 2293
- Joined: 25 Jan 2019, 01:28
- Antispam: Yes
Re: import files from solidworks
Can you post one of these exported files?
Re: import files from solidworks
Thanks for your reply,
here's a .step file.
here's a .step file.
-
- Posts: 2293
- Joined: 25 Jan 2019, 01:28
- Antispam: Yes
Re: import files from solidworks
Used step file to make mesh in gmsh. Elmer would not read msh file
used help, current options, searched on mesh.format
clicked mesh.format=10 and change the the value to 2
save mesh, saves as a unv file (universal file)
ElmerGUI opened it no problem
gmsh
Elmer
used help, current options, searched on mesh.format
clicked mesh.format=10 and change the the value to 2
save mesh, saves as a unv file (universal file)
ElmerGUI opened it no problem
gmsh
Elmer
-
- Site Admin
- Posts: 4823
- Joined: 22 Aug 2009, 11:57
- Antispam: Yes
- Location: Espoo, Finland
- Contact:
Re: import files from solidworks
Kevin, could you sent the .msh file for me for inspection. -Peter
-
- Posts: 2293
- Joined: 25 Jan 2019, 01:28
- Antispam: Yes
Re: import files from solidworks
msh file created by gmsh
-
- Site Admin
- Posts: 4823
- Joined: 22 Aug 2009, 11:57
- Antispam: Yes
- Location: Espoo, Finland
- Contact:
Re: import files from solidworks
Hi Kevin,
When I open this in ElmerGUI and click on the same BC I get this attached picture.
I now there are some complaints about 1D BCs but ElmerGUI cannot deal with them anaways...
Can you not "Open" the .msh file in ElmerGUI?
-Peter
When I open this in ElmerGUI and click on the same BC I get this attached picture.
I now there are some complaints about 1D BCs but ElmerGUI cannot deal with them anaways...
Can you not "Open" the .msh file in ElmerGUI?
-Peter
-
- Posts: 2293
- Joined: 25 Jan 2019, 01:28
- Antispam: Yes
Re: import files from solidworks
Peter,
Yes I can, for some reason I thought I could not. I tried again and it worked fine. Must have grabbed the wrong file earlier.
So you can open the step file in gmsh, mesh, do file save mesh, then open the msh file in ElmerGUI
Kevin
Yes I can, for some reason I thought I could not. I tried again and it worked fine. Must have grabbed the wrong file earlier.
So you can open the step file in gmsh, mesh, do file save mesh, then open the msh file in ElmerGUI
Kevin
Re: import files from solidworks
Kevin,
Finally it worked well.
Thank you so much!
Finally it worked well.
Thank you so much!