Impossible to select bodies

The graphical user interface of Elmer
Rich_B
Posts: 421
Joined: 24 Aug 2009, 20:18

Re: Impossible to select bodies

Post by Rich_B »

Loading the test.msh file in ElmerGUI, automatically added a single boundary around the outside edge of the 2D triangle mesh. Using the Divide Edge command, ElmerGUI then was able to split the single boundary into four boundaries. For this sample mesh, I had to change the default value for 'sharp edge angle' from 20 to 15 degrees.

Rich.
kevinarden
Posts: 2237
Joined: 25 Jan 2019, 01:28
Antispam: Yes

Re: Impossible to select bodies

Post by kevinarden »

I have been creating boundaries in the external meshers for so long, I forgot about the split command. Thanks.
Post Reply