Hello,
Looking at the test poly file, the last section with attributes shows three regions. The three regions are meant to be the materials, and the three areas look to be marked as such in the .ele file, as you mentioned. Doesn't look like elmergrid understood the three materials should be three bodies.
Also, elmergrid ignored the negative boundary number, -2. Changing the -2 to be a 2, allowed elmergrid to locate the outer boundary.
Rich.
What mesh generation software do you use?
Re: What mesh generation software do you use?
Yes.
I guest that the only thing to do is to allow to do the conversion without the poly file and identify the bodies from the .ele file. If i have some time, I'll take a look into the code.
Thanks for the help.
I guest that the only thing to do is to allow to do the conversion without the poly file and identify the bodies from the .ele file. If i have some time, I'll take a look into the code.
Thanks for the help.
-
- Site Admin
- Posts: 4841
- Joined: 22 Aug 2009, 11:57
- Antispam: Yes
- Location: Espoo, Finland
- Contact:
Re: What mesh generation software do you use?
This may improve things:
https://github.com/ElmerCSC/elmerfem/co ... ad18c12169
https://github.com/ElmerCSC/elmerfem/co ... ad18c12169