I tried to import a .stp file to generate a from it. However I get the following message:
```
Unable to (re)mesh: no input data or mesh generator (please make sure that your input file suffix is in lower case)
````
I have read the following community post
https://www.elmerfem.org/forum/viewtopi ... =Stp#p7749
https://www.elmerfem.org/forum/viewtopi ... Stp#p17142
however the ElmerTutorials mention that it is possible to import .stp files and mesh them using nglib
https://www.nic.funet.fi/pub/sci/physic ... orials.pdf
which should be installed during compilation
https://www.nic.funet.fi/index/elmer/do ... Manual.pdf
Do you have any suggestions
Importing STP files not working
-
- Posts: 2355
- Joined: 25 Jan 2019, 01:28
- Antispam: Yes
Re: Importing STP files not working
It works on my W10 installation, but I get the same error as you on Ubuntu. Both were installed using the binaries, not compiled.
Re: Importing STP files not working
Well I compiled mine using the aur and the git. So it seems it is a problem with the Linux version