ElmerGui calculations

The graphical user interface of Elmer
Post Reply
busrasahh
Posts: 1
Joined: 19 Jan 2024, 18:56
Antispam: Yes

ElmerGui calculations

Post by busrasahh »

Hello, there is excessive vibration in the structure due to the machines of a factory. Does it make sense to use Elmer to solve this? Can we calculate vibration in Elmer?
kevinarden
Posts: 2367
Joined: 25 Jan 2019, 01:28
Antispam: Yes

Re: ElmerGui calculations

Post by kevinarden »

You can use Elmer to calculate vibration. Excessive vibration in structure to machines is caused by the operating frequency of the machinery being to close in resonance with the structure frequency, often referred to as resonance. If a rotary machine is operating at 60 Hz than excessive vibrations will be experience if the structure is close to that frequency.
resonance.png
resonance.png (82.81 KiB) Viewed 883 times
Many just keep bracing the structure until it is stiff enough to avoid the resonance (trial and error), however isolation is the other option. (mounting the machines on soft mounts so the vibrations won't transmit into the structure.

Elmer can calculate the frequencies of the structure to determine how much in resonance it is, and if modifications are enough to change the structure frequency out of resonance.
kevinarden
Posts: 2367
Joined: 25 Jan 2019, 01:28
Antispam: Yes

Re: ElmerGui calculations

Post by kevinarden »

This is an example of a forced vibration analysis where the load is applied at various frequencies to determine where it goes in resonance to the structure.

viewtopic.php?t=7299
Post Reply