There are no Solvers in the System
Posted: 14 Oct 2020, 14:11
Hi, I am very new to Elmer and I am trying to simulate a heat transfer process on a brick wall with conduction, convection, and radiation. However, this error appeared on the Solver Log (attached below).
What should I do? I tried searching this error on the Forum's search bar and as far as I know there are no forum with this error return.
Any help is appreciated. Thank you very much
ELMER SOLVER (v 8.4) STARTED AT: 2020/10/14 18:02:58
ParCommInit: Initialize #PEs: 1
MAIN:
MAIN: =============================================================
MAIN: ElmerSolver finite element software, Welcome!
MAIN: This program is free software licensed under (L)GPL
MAIN: Copyright 1st April 1995 - , CSC - IT Center for Science Ltd.
MAIN: Webpage http://www.csc.fi/elmer, Email elmeradm@csc.fi
MAIN: Version: 8.4 (Rev: Release, Compiled: 2020-08-03)
MAIN: Running one task without MPI parallelization.
MAIN: Running with just one thread per task.
MAIN: Lua interpreted linked in.
MAIN: =============================================================
LoadInputFile: Reading only "Run Control" section
MAIN:
MAIN:
MAIN: -------------------------------------
MAIN: Reading Model: case.sif
LoadInputFile: Scanning input file: case.sif
LoadInputFile: Scanning only size info
LoadInputFile: First time visiting
LoadInputFile: Reading base load of sif file
LoadInputFile: Loading input file: case.sif
LoadInputFile: Reading base load of sif file
LoadInputFile: Number of BCs: 2
LoadInputFile: Number of Body Forces: 0
LoadInputFile: Number of Initial Conditions: 1
LoadInputFile: Number of Materials: 1
LoadInputFile: Number of Equations: 1
ERROR:: LoadInputFile: There are no Solvers in the system!
STOP 1
What should I do? I tried searching this error on the Forum's search bar and as far as I know there are no forum with this error return.
Any help is appreciated. Thank you very much
ELMER SOLVER (v 8.4) STARTED AT: 2020/10/14 18:02:58
ParCommInit: Initialize #PEs: 1
MAIN:
MAIN: =============================================================
MAIN: ElmerSolver finite element software, Welcome!
MAIN: This program is free software licensed under (L)GPL
MAIN: Copyright 1st April 1995 - , CSC - IT Center for Science Ltd.
MAIN: Webpage http://www.csc.fi/elmer, Email elmeradm@csc.fi
MAIN: Version: 8.4 (Rev: Release, Compiled: 2020-08-03)
MAIN: Running one task without MPI parallelization.
MAIN: Running with just one thread per task.
MAIN: Lua interpreted linked in.
MAIN: =============================================================
LoadInputFile: Reading only "Run Control" section
MAIN:
MAIN:
MAIN: -------------------------------------
MAIN: Reading Model: case.sif
LoadInputFile: Scanning input file: case.sif
LoadInputFile: Scanning only size info
LoadInputFile: First time visiting
LoadInputFile: Reading base load of sif file
LoadInputFile: Loading input file: case.sif
LoadInputFile: Reading base load of sif file
LoadInputFile: Number of BCs: 2
LoadInputFile: Number of Body Forces: 0
LoadInputFile: Number of Initial Conditions: 1
LoadInputFile: Number of Materials: 1
LoadInputFile: Number of Equations: 1
ERROR:: LoadInputFile: There are no Solvers in the system!
STOP 1