While "Mesh" is very fine, a flow velocity is too large.
Posted: 16 Jun 2023, 05:54
My name is Mashimo.
I create a mesh with an air flow very fine by the salome, because of avoiding errors of "mesh is over lapping". But in the result of the elmer analysis,a flow velocity is too large. Cannot this result be avoided ?
Mail address: mashimo@polka.ocn.ne.jp
I create a mesh with an air flow very fine by the salome, because of avoiding errors of "mesh is over lapping". But in the result of the elmer analysis,a flow velocity is too large. Cannot this result be avoided ?
Mail address: mashimo@polka.ocn.ne.jp