Issue with ElmerGrid when Editing Internal Vertices
Posted: 10 Mar 2024, 18:17
I'm currently working on a 3D magnetostatics project involving a simple magnet suspended in the air. In my initial attempt, I used a cylinder, and the mesh created with FreeCAD and Salome seamlessly converted using either ElmerGrid or ElmerGUI.
However, upon transitioning to a more complex model, consisting of a cube within a cube, I encountered an issue. Although the model converts successfully, attempting to edit the internal body leads to a segmentation fault. Additionally, when I hide the air volume, the internal volume appears to be missing.
Any insights or suggestions on resolving this matter would be greatly appreciated. Thank you!
However, upon transitioning to a more complex model, consisting of a cube within a cube, I encountered an issue. Although the model converts successfully, attempting to edit the internal body leads to a segmentation fault. Additionally, when I hide the air volume, the internal volume appears to be missing.
Any insights or suggestions on resolving this matter would be greatly appreciated. Thank you!