I'm trying to use Elmer for a relatively simple acoustics case, but being new to this I fear I'm not going to finish it on time with the assurance of correctness. I'm interested to know if one of you would be available to setup a simulation.
For an indication, please find attached an image of the geometry (from ElmerGUI; length 30m), where the red surfaces are reflective, and the others are open boundaries. The desired output is the sound level at a certain point with a point source at the origin, for roughly 200-2000Hz. it would be great if we could then take the setup and experiment with different geometries. The goal is to see if this reduced parabolic reflector  with holes would still work.
Our budget is not too big, but if you're versed in Elmer I think this should not be such a hard case.
Looking forward to your response by private message.
 http://www.sfu.ca/sonic-studio/handbook ... ector.html
A forum for commercial service requests and offerings
1 post • Page 1 of 1