I have a simple simulation of flow in a tube (axisymmetric case). I would like to save the output as *.vtu files. However, I'm not able to visualize them. After failing to display the results in both ParaView and Visit and looking at http://www.elmerfem.org/wiki/index.php/ParaView , I checked whether the data in the output files are correct. Scalar variables (pressure in my case) seem to be fine, but for vector variables (velocity field, mesh displacement etc.), I see this:
Code: Select all
<DataArray type="Float32" Name="velocity" NumberOfComponents="3" format="ascii">
0.000000E+000 0.419648E-0010.0 0.199380E+000 -0.190733E-0220.0 0.0 0.0 0.0 0.000000E+000 0.419706E-0010.0 0.000000E+000 0.419664E-0010.0 0.000000E+000 0.419774E-0010.0 0.000000E+000 0.419686E-0010.0 0.000000E+000 0.419654E-0010.0
...
</DataArray>
Visit was able to read the first block of the mesh (I tried with 2 and with 3 partitions of my mesh), but doesn't load the following blocks ( it doesn't actually read any variables from the second or third file).
I was wondering if you could be so kind and point me to the place in source code where I could fix the output routine. I'm using sources from svn repository and updated to the latest revision.
Best regards,
Martin Vymazal