Open ParaView from ElmerGUI
Posted: 29 Feb 2016, 17:17
Hi,
in the new ElmerGUI that comes with Elmer 8.x, one can start ParaView directly for postprocessing (if the system Path points to the bin directory of the ParaView installation).
I have just tested it for the first time - it works fine if one has given a .vtu file as "Post file" name in the Simulation section (Model > Setup in ElmerGUI). It doesn't seem to work if I use ResultOutputSolver instead, e.g. to write a pvd time collection file (.pvd) so that ParaView sees the timesteps with their real value. I can open the .pvd manually in ParaView without problems.
Questions:
1) Is this supposed to work with ResultOutputSolver? If so, what did I do wrong?
2) Could there be a way to tell ElmerGUI to open ParaView with the file(s) written by ResultOutputSolver?
Thanks,
Matthias
in the new ElmerGUI that comes with Elmer 8.x, one can start ParaView directly for postprocessing (if the system Path points to the bin directory of the ParaView installation).
I have just tested it for the first time - it works fine if one has given a .vtu file as "Post file" name in the Simulation section (Model > Setup in ElmerGUI). It doesn't seem to work if I use ResultOutputSolver instead, e.g. to write a pvd time collection file (.pvd) so that ParaView sees the timesteps with their real value. I can open the .pvd manually in ParaView without problems.
Questions:
1) Is this supposed to work with ResultOutputSolver? If so, what did I do wrong?
2) Could there be a way to tell ElmerGUI to open ParaView with the file(s) written by ResultOutputSolver?
Thanks,
Matthias