Default value for "Setup -> Coordinate Scaling"
Posted: 29 Jun 2023, 14:41
Dear Elmer Forum members,
I have a question regarding the default value setting for Coordinate Scaling in the Elmer setup window. I'm curious to know where to set the default value for this parameter. I'm working on Windows and was not able to find something in the *.efg or *.ini files.
My current workflow is FreeCAD->SETP->gmsh.exe->msh->elmer, so that 0.001 Coordinate Scaling is consistently required for SI units due to gmsh default conventions (SETP files with unit in meter or mmilli meter are converted to mm).
Any information or suggestions regarding the location or method to modify the default value of Coordinate Scaling would be greatly appreciated.
Thank you for your time and expertise!
Best regards,
Danny
I have a question regarding the default value setting for Coordinate Scaling in the Elmer setup window. I'm curious to know where to set the default value for this parameter. I'm working on Windows and was not able to find something in the *.efg or *.ini files.
My current workflow is FreeCAD->SETP->gmsh.exe->msh->elmer, so that 0.001 Coordinate Scaling is consistently required for SI units due to gmsh default conventions (SETP files with unit in meter or mmilli meter are converted to mm).
Any information or suggestions regarding the location or method to modify the default value of Coordinate Scaling would be greatly appreciated.
Thank you for your time and expertise!
Best regards,
Danny