some questions about [3d Magdyn,Wsolver,CoilSolver,circuit]
Posted: 07 Jan 2024, 12:58
Hi,
There is a model with two coils twist with each other,as shown in the figure.
As I connect [Coil.1] in series with alternating current source.The two sides of [Coil.2] are grounded so there will be induced circulation current in it.I would like to calculate the induced current in [Coil.2] and the voltage of the two coils.Here are the questions:
(1)Should [Coil.1] and [Coil.2] be calculated with "Wsolver" or "CoilSolver"?
(2)How to make the two sides of [Coil.2] grounded(as shown in the figure),by "Wsolver" or "CoilSolver" or "circuit"?
Could anyone provide similar cases?Anyhelp is appreciated.
Joseph
There is a model with two coils twist with each other,as shown in the figure.
As I connect [Coil.1] in series with alternating current source.The two sides of [Coil.2] are grounded so there will be induced circulation current in it.I would like to calculate the induced current in [Coil.2] and the voltage of the two coils.Here are the questions:
(1)Should [Coil.1] and [Coil.2] be calculated with "Wsolver" or "CoilSolver"?
(2)How to make the two sides of [Coil.2] grounded(as shown in the figure),by "Wsolver" or "CoilSolver" or "circuit"?
Could anyone provide similar cases?Anyhelp is appreciated.
Joseph