Hi to all.
I am modelling a mechanical piece and have a problem with imposing boundary conditions. I need a face to move along one direction only and when I create a BC like "Displacement 3 = 0" I find, when viewing the postprocessor, that elmer has set all the three displacements equal zero, i.e.: Displacement 1 = Displacement 2 = Displacement 3 = 0. How can I fix it?
Thanks
Franco
problem with displacement BCs
Re: problem with displacement BCs
Hej Franco,
It is difficult to say without more information. Could you post your working files?
If you just want to allow the boundary to move only in one direction; shouldn't you restricit the other two?
/Xavi
It is difficult to say without more information. Could you post your working files?
If you just want to allow the boundary to move only in one direction; shouldn't you restricit the other two?
/Xavi
Re: problem with displacement BCs
Hi Franco,
It would be easier to state on your question if you paste the content of your SIF in the forum or at least a part of it.
Yours
Anil Kunwar
It would be easier to state on your question if you paste the content of your SIF in the forum or at least a part of it.
Yours
Anil Kunwar
Anil Kunwar
Faculty of Mechanical Engineering, Silesian University of Technology, Gliwice
Faculty of Mechanical Engineering, Silesian University of Technology, Gliwice