Hello Elmer team
I want to view a very narrow part of my model in ElmerPost but after a particular times of 'zooming in' the model disappears. Is there any way to fix this problem, i.e., to be able to zoom in a greater number of times?
Sincerely yours,
Zhanna
Zoom in
Re: Zoom in
Hi Zhanna,
your trouble is that the "camera" near clipping plane is reached.
If you take the Edit -> Camera Settings panel, change the "Projection"
from "Perspective" to "Ortho", you can put a (large) negative number on
the "near clip" input field.
this should do it, Juha
your trouble is that the "camera" near clipping plane is reached.
If you take the Edit -> Camera Settings panel, change the "Projection"
from "Perspective" to "Ortho", you can put a (large) negative number on
the "near clip" input field.
this should do it, Juha