Hi,
I am just starting out with Elmer and was trying to simulate a load on a disc.
When I press the "Run ElmerSolver" button, Windows reports ElmerSolver.exe has stopped working,
in the Solver log there are a few entries and the solution looks like is converges but it does not
generate the input files for the post processor.
I don't where I am making a mistake. I would appreciate it if you could give me pointer to what I should
change. The relevant files of the project are in the attachment.
Thank you.
-Indroneel.
Elmer Solver doesn't generate Elmerpost input file
-
- Posts: 2
- Joined: 26 Oct 2009, 22:09
Elmer Solver doesn't generate Elmerpost input file
- Attachments
-
- case.zip
- (81.92 KiB) Downloaded 404 times
Re: Elmer Solver doesn't generate Elmerpost input file
Hi and welcome,
I just tried running your project on two different machines, and it worked well in both cases.
Which version of ElmerGUI/ElmerSolver are you using? The lastest Windows builds can be downloaded from nic.funet.fi My tests were based on rev 4259 from yesterday.
I just tried running your project on two different machines, and it worked well in both cases.
Which version of ElmerGUI/ElmerSolver are you using? The lastest Windows builds can be downloaded from nic.funet.fi My tests were based on rev 4259 from yesterday.
-
- Posts: 2
- Joined: 26 Oct 2009, 22:09
Re: Elmer Solver doesn't generate Elmerpost input file
Hi !
I am using Elmer version 6.0 (from installation directory) and Solver 5.5.0 (what i noticed in the server log).
Is there another way to check to the version numbers ?
Just before I installed the latest build, I tried to run it again.
It worked fine and the post processor showed the results.
But I am sure it had given me the windows error and no post processor input
was generated. The convergence monitor has a different looking graph now, previously the error would occur
before the convergence graph was fully drawn.
Thanks a lot!
-Indroneel.
I am using Elmer version 6.0 (from installation directory) and Solver 5.5.0 (what i noticed in the server log).
Is there another way to check to the version numbers ?
Just before I installed the latest build, I tried to run it again.
It worked fine and the post processor showed the results.
But I am sure it had given me the windows error and no post processor input
was generated. The convergence monitor has a different looking graph now, previously the error would occur
before the convergence graph was fully drawn.
Thanks a lot!
-Indroneel.